tech_nut_slip

Unistrut Asia Products

Nut Slip & Pullout - Performance - Zinc Plated

Slip and Pullout Performance - Zinc Plated

Channel Type	Nut Type	Pullout	Slip	Torque
Channel Type	Nut Type	kN	kN	Nm
P1000	P1006	7.3	2.7*	9
	P1007	10.1	5.2*	22
	P1008	16.5	8.7*	44
	P1010	16.5	12.9*	77
P2000	P3016	2.1	0.3	9
	P1006	4.8	1.1*	9
	P1007	5	4.0*	22
	P1008	10.8	7.1*	37
	P1010	10.8	6.7*	37
P3300	P3016	2.2	0.6	9
	P4006	7.3	2.7*	9
	P4007	10.1	5.2*	22
	P4008	16.5	8.7*	44
	P4010	16.5	12.9*	77
P4000	P3016	2.1	0.3	9
	P4006	4.8	1.1*	9
	P4007	5	4.0*	22
	P4008	10.8	7.1*	37
	P4010	10.8	6.7*	37
A1000	A1008	11.3	3.7*	44
P5500	P5508	16.5	8.7*	44
P5500	P5510	16.5	12.9*	77

“Load capacities have been calculated in accordance with the provisions of AS/NZS 4600:1996 “Cold-formed steel structures”, and in particular, Section 6.2.2.7. The bolting system chosen using the data provided in the tables will perform as specified when design, fabrication and erection are carried out in accordance with Unistrut’s recommendations and accepted building practice”.

Note:
To simplify the table, channel nuts with springs only shown with the exception of P3016. Unistrut nuts without springs will have identical performance.

Figures marked with (*) in the table opposite were obtained using high strength (Grade 8.8) screws.

Figures not marked with (*) were obtained using standard strength (Grade 4.6) screws. It should be noted that unless otherwise specified, standard strength screws (Grade 4.6) are supplied.

For Slip Loads using 4.6 Grade Commercial bolts and screws, Contact your local Unistrut Service Centre.

Hot Dipped Galvanised Channel Nuts
• Apply Pullout Loads as listed
• For Slip Loads - refer to your local Unistrut Service Centre.